Looking like solid work so far mate, great job! What is the modelling putty that you are using?
Nurgle Heldrake, out of the earth
(Edit)Heldrake not hedlake
![]()
After "dry" fitting, I found I used a little too much super glue on one of the ball/ key joints. Causing me to break a 1/16 pinning ball drill bit (its just a round ball drill bit) I will have to replace that. When I dry fit I tack a small amount of super glue onto one or two spots on the model, after dropping the head 3 times it separated. The wing in the first picture I had use a little too much glue and had issues. In the end I cut through both pieces, positive side the joint is completely mobile now.
I've made some cybernetic hoses that will be added to the body,
![]()
I would have rather had more done on this but have sidetracked on paint removal from some old plastics....
![]()
Until next time.
After "dry" fitting, I found I used a little too much super glue on one of the ball/ key joints. Causing me to break a 1/16 pinning ball drill bit (its just a round ball drill bit) I will have to replace that. When I dry fit I tack a small amount of super glue onto one or two spots on the model, after dropping the head 3 times it separated. The wing in the first picture I had use a little too much glue and had issues. In the end I cut through both pieces, positive side the joint is completely mobile now.
I've made some cybernetic hoses that will be added to the body,
I would have rather had more done on this but have sidetracked on paint removal from some old plastics....
Until next time.
3
1 - 2 of 10 Posts
1 - 2 of 10 Posts
