[mrknify]

(Edit)Heldrake not hedlake

After "dry" fitting, I found I used a little too much super glue on one of the ball/ key joints. Causing me to break a 1/16 pinning ball drill bit (its just a round ball drill bit) I will have to replace that. When I dry fit I tack a small amount of super glue onto one or two spots on the model, after dropping the head 3 times it separated. The wing in the first picture I had use a little too much glue and had issues. In the end I cut through both pieces, positive side the joint is completely mobile now.

I've made some cybernetic hoses that will be added to the body,

I would have rather had more done on this but have sidetracked on paint removal from some old plastics....

Until next time.

 

[Moriouce]

You know you can edit the title of your thread right?
It all looks promising though!

 

[Dorns Legacy]

i prefer Nurgle Hedlake to Heldrake tbh

 

[mrknify]

You know you can edit the title of your thread right?
It all looks promising though!

Unfortunately not on my phone.


I've been looking for my cornerstone piece for the base, I want an old tower or wall. Just not able to find one with the look I want...

It needs to be able to "fit" on the flyer base and no higher then 12".

I may just use a milk bottle for it... lol I will figure out what to use, and suggestions are welcome.

 

[mrknify]

Hijacking my own thread instead of starting a new one to avoid clutter.

ADD kicking in... so I've moved onto my cultists while I have the Muse. Tue drakes are paused while waiting for parts.

Like the paint box? My first one still have most of the paints and they still work!

I have 9 more renegade torsos. I've Given up on getting guard legs and will be "mutating" them with various legs I can find.

The prince was an older job back when DP of tzeentch were amazing. His wing mounts are going to be cut off and replaced with a nice jet pack.

The mordhiem cultist hand is getting flipped the knife removed and a pistol put in its place.

Kharn ... need a hand have been toying with making him a flamer. Heh a blind guy with a flame thrower.

Goat legs needs another kroot arm to finish him up, of course his gun needs more work.

 

[mrknify]

Its been awhile... this conversion still sits in a box. I have almost compleated another nurgle conversion for the april conversion contest, I will just put a spoiler here for now ;0

 

[Iraqiel]

Looking like solid work so far mate, great job! What is the modelling putty that you are using?

 

[mrknify]

Milliput;

Its a bit funny this one acts a bit more like a clay. It sculpted really nicely although it need a few minutes after mixing to be good for rolling.

 

[Iraqiel]

Milliput

Excellent, thanks!

 

[neferhet]

i'm waiting to see the finished work you truly are fascinated by the helturkey!