Warhammer 40k Forum and Wargaming Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
110 Posts
Discussion Starter · #1 ·
Hey all,

Hope this is the right place. I'm after some advice.

I have a couple of PVC material gaming mats which I'd like to mount onto thick card and then chop up in small sections for ease of storage and carrying.

However, I'm a bit lost as to how to get the mat stuck to the board and, then, how to get the sections to connect (obviously I don't want them just sitting next to each other, they need some form of clip).

The mats are currently stored rolled up in the tube they arrived in, but I'm not keep on it.

Anyone any experience in this?

thank you.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top