4
Came into owning some Grey Knight models in a trade a while back, and with the release of the new Codex I have decided to change up what the Terminators came armed with. Ultimately, I came up one Nemesis Hammer short for the squad and had to improvise.
I had all the necessary parts. Left is the terminator pretty much as I got him but without a hand. Then there's the Terminator sized hand I needed attached to the Halberd, the bottom of the staff I need from a Ward Stave, and the top half of the Hammer that would be taken off that Grey Knight model.
Took me a couple minutes to actually get this part done. After cutting the pieces out I had to drill them out for stability's sake.
Here is what I ended up with, I opted out of adding any haft above the hand as it looked pretty damn close to the one that I am using for my Librarian to lead the squad.
Hmm...looking at that now I don't think the hand is big enough, but at least it's on the right angle. Here's the completed model:
I had all the necessary parts. Left is the terminator pretty much as I got him but without a hand. Then there's the Terminator sized hand I needed attached to the Halberd, the bottom of the staff I need from a Ward Stave, and the top half of the Hammer that would be taken off that Grey Knight model.
Took me a couple minutes to actually get this part done. After cutting the pieces out I had to drill them out for stability's sake.
Here is what I ended up with, I opted out of adding any haft above the hand as it looked pretty damn close to the one that I am using for my Librarian to lead the squad.
Hmm...looking at that now I don't think the hand is big enough, but at least it's on the right angle. Here's the completed model:
