Warhammer 40k Forum and Wargaming Forums banner

Imperial Fists WIP

1295 Views 7 Replies 3 Participants Last post by  Words_of_Truth
Ok so i thought i would start this thread off, to get ready for my Imperial fists. So far it will aim to be 1500 and will include-

Captain Eeifmund of the 5th Company (Master)
Where i shall be using the power sword and antique bolter carrying masters from the new master of the chapter box.

9 Man Command Squad with x2 Missile Launcher
These shall have the veteran shoulder pads available from the online store.
I was hoping to use the new missile launchers from the devastator box but the fact they are only available in the devastator boxs means i'll have to use the standard tactical ones.



Dreadnaught Yanyr, Former Captain of the 5th Company
Twin-Linked Lascannon, Smoke Launchers, Extra Armour

For this guy i thought i would make him special because fluff wise he was a former captain, To do this i shall be using the mark IV dreadnaught from forgeworld along with the special dreadnaught drilling arm (i think it would look good considering imperial fists are masters of seiges) and imperial fists markings and the scenenic base which are also available from FW


10 Man Tactical Squad with Heavy Bolter and Flamer
I shall be using the tactical squad and chapter shoulder badges available from online store. Again i was hoping to use the devastator plastic heavy bolter marines but again its not cost effective and would be a waste.


9 Man Tactical Squad with Heavy Bolter and Flamer
Same as above


Land Speeder Multi-Melta
For all my landspeeders i shall be buying the assault squad pads to fit the crews with them.


Land Speeder Tornado with Heavy Bolter and Assault Cannon
same as above

Land Speeder Tornado with Heavy Bolter and Assault Cannon
same as above

10 Man Devastator Squad with 4 Missile Launchers
I need to figure out how to get more missile launchers as only buying three tatical squads ill only provide three missile launchers i need a total 6

Vindicator with Extra Armour and Smoke Launchers
Shall be using the forge world model and most likely the imperial fist doors.

Whirlwind
Again using the forge world version and this time using the imperial front panels and doors.

Thats what i am hoping to get, it shall cost a bit but i am taking my time with it, i've started by buying the first squad and shoulder pads :) will see if i can get any good pictures of them up.
See less See more
1 - 2 of 8 Posts
sounds good, though seems like buying a dev box might not be that bad for you, given how many HBs and MLs you need. plus youve always got the spare weps for later.
you need 3 tac squad boxes yeah? thats 3 MLs, 1 from devs, can you scrounge 2 more?
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top