Warhammer 40k Forum and Wargaming Forums banner
1 - 1 of 1 Posts

· Angryman
Joined
·
4,277 Posts
The two main hull halves are identical. One upside down and one upright with the sloping hull front/back pannels in opposite directions. Makes a rhombus shape. Line up the hull top at the rear with the narrow vertical so there is no gap. There will be a circular-ish hole in either side(with two squared off corners) the circular raised section on each of the track frames go in here. From there it should be easy.

Damn ninjas.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top