Warhammer 40k Forum and Wargaming Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
Hi there.

I got the SoB bits to add to a tank, as well as the FW doors for my whirlwind/exorcist. So it'll look similar to the FW Exorcist, but with the WW turret instead of a custom one.

Sorry that this is a pretty dumb question, but how do I glue FW resin to GW plastics?

I'd be happy if I can use Polystyrene Cement, as I much prefer that to super glue, but I know it only works properly on poly plastics.

Thanks!
 

·
Registered
Joined
·
61 Posts
Discussion Starter · #3 ·
Okay. Cheers. I thought as much, but thought I'd double check to be sure.

Straightening the resin isn't a problem, I'll just run it under the hot tap. Much the same as DnD minis, but it probably needs more heat.
 

·
Drinker of tea...
Joined
·
2,277 Posts
Daz, make sure you wash that resign with soap and a soft toothbrush too. I had a bit of a problem with my resin bits falling apart after i thought they were stuck...
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top