Warhammer 40k Forum and Wargaming Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
363 Posts
Discussion Starter · #1 ·
Ok so I've come to make my Trueborn for my growing Kabal and instead of buying 4 boxes of warriors to get the 4 blasters I needed I've used a simple conversion to double the amount of blasters from each box.

Here is the original blaster


Here is the 'new' blaster


and here is a side by side comparison


The conversion is simple take the shredder and clip off the end of the barrel leaving the cooling rings and then clip off the ammo canister. Then take the blast pistol and clip off the barrel drill and pin this to the shredder. Done!

Probably already been done but I think it's quite effective and worth mentioning.
 

·
Registered
Joined
·
363 Posts
Discussion Starter · #4 ·
Very nice, this will come in handy. I wouldn't mind some more pictures of each of the parts you used though. If that would be possible?
Did the conversion at work but a little borrowing and editing of photos (thanks Bitz box)

Shredder (black lines indicate cuts)


Blast Pistol (black line indicates cut)


Hope that helps
 

·
Searching for Vulkan
Joined
·
2,755 Posts
To be honest the difference is so subtle I can't even tell there is a difference. I'm not sure if it's what you've achieved, or if it's just something so subtle it's not worth doing! Good job man, I'm just not up on my Dark Eldar Lore yet! :)
 
1 - 6 of 6 Posts
Top