Warhammer 40k Forum and Wargaming Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,868 Posts
Ok, here is a quick run down.

Hot water will bend them back into place if they're warped.
Use a scraping tool to smooth out places where you've removed those mold nubs.
Scalpel typically works best, IMHO, to remove very annoying flash in hard to reach places.
Keep liquid Green Stuff on hand to fill in bubbles and gaps in the cast.
Glue with Super Glue.
Also, it doesn't hurt to give the model a short bath in warm soapy water and gently scrub any mold release that may still be on it.
 
1 - 2 of 2 Posts
Top