Warhammer 40k Forum and Wargaming Forums banner


8281 Views 7 Replies 7 Participants Last post by  Raizer Sabre
For those of you want some battle damage on your models, here is a nice tutorial.
I am using my bandages as mummy wrap on my CSM, but someone could use them as eye patches, or on limbs to represent bandages as well (it would look nice on IG units)
Once I get back from class today, I will add pictures for every step to make it easier for people.

Supplies needed:

White Glue (like Elmer's school)
Model Glue
Printer paper
Razorblade (or scissors)
A dirty paintbrush you don't care about

Step 1. Cut the paper into strips that are thin enough to your needs.

Step 2. Place a small dab of model glue on the desired starting point for the bandage. Let it dry.

Step 3. Once it is dry, wrap the desired piece until you are satisfied, or your strip runs out. Then use another small dab of superglue to hold it in place.

Step 4. Once it is dry again, take your paint brush and dip it in the glue. Put a medium thickness glaze around the entire area that was covered. It might take 2 or more coats for the paper to harden, so be patient.

Step 5. Once your model is dry, it is read for paint. Prep it like you would any normal paint job (including primer).

Step 6. Optional. If you want it to look dirty, here is how I painted mine. Using a slighly off-white base, I covered all the bandage areas. I then put a heavy coat of ogryn flesh wash over the entire bandage to give it a weathered effect.

Your final results should look similiar to this (well, not as covered if you did bandages, as these are my mummy marines)

If you have any questions, feel free to ask.
See less See more
1 - 1 of 8 Posts
I actually like the mummys, it would go well with a deathguard army. i might make some nurgle mummys now
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.