Originally Posted by Ring Master "Honka"
I had a model I took back once because an air bubble had removed the entire face.
makes me miss the days of metal models. sure the paint liked to chip off but the models were always well done and if they were bent you could bend them back into shape
Well I think the Finecast is decent to bend back into place with hot water. The air-bubles are impossible to do anything about though. But yeah you could depend on the metal at least.
Very nice base you got going there! I will be checking out how you did it and what steps you went through.
My initial thought and advice, would be to have a look at your wash control. There are some places where the wash has pooled and dried uneven on your model and it takes it down a notch. You are making some good progress though!
Always good to see more Word Bearers
Keep it up!
Thank you for your comment! Yes, I would say the wash is a bit Chaotic to control. I often let it be as when I try and fix it up, it turns out for the worse rather than the better.
But I thank you for oyur feed-back.