Wargaming Forum and Wargamer Forums - Reply to Topic
Thread: Pinning II Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Wargaming Forum and Wargamer Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
10-08-08 03:00 AM
dirty-dog- lol, it would be funny if you were pinning an ork nob.

glue tip of rod and isert into nob arm lol
10-08-08 01:22 AM
Djinn24 You would love my purple phone then :p.
10-07-08 10:05 PM
Death 0F Angels im diggin the purple clipers dude, very masculine : P
09-25-08 12:28 AM
Pinning II

I created this because it was still in the tutorial request (glares) so if need be combine them.

1. Select a model that needs to be pinned because it has a week or awkward join. This is normally needed mainly on metal or resin minis, though you can pin plastic as well. I selected a Daemon Hunter model that has a decent arm join but has a tendency to be knocked off if his due to it sticking out.

2. I get my tool and prepare them. I use brass rods available from train, craft, or hobby stores. I get mine from Hobby Lobby. 5 x 12 inch (or longer) brass rods for 3.50 dollar. I also use a dremo micro drill bit set, 5 very small bits for 7.00 dollars.

For this job I selected a 1/8inch brass rod.

3. Drill a hole in the large piece, as close to the middle of the joint.

4. Test fit the rod (optional).

5. Cut a piece of rod that is shorter then what you plan on using. A bit longer then flush. Put a drop of paint on the end of the rod.

6. Put the small piece to the rod.

It will leave a small drop of paint where you need to drill.

7. Drill into the smaller piece.

8. Cut a section of rod and place it into the peice and test fit it. If you find the rod too long, you can either trim the end off, or drill the hole a bit deeper.

9. Glue the tip of the rod (insert joke here) the join and the other tip of the rod and insert into the model, hold until dry.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome