Wargaming Forum and Wargamer Forums - View Single Post - Pinning II
Thread: Pinning II
View Single Post
post #1 of (permalink) Old 09-25-08, 12:28 AM Thread Starter
Djinn24
Junior Member
 
Djinn24's Avatar
Djinn24's Flag is: USA
 
Join Date: Jan 2008
Posts: 0
Default Pinning II

I created this because it was still in the tutorial request (glares) so if need be combine them.

1. Select a model that needs to be pinned because it has a week or awkward join. This is normally needed mainly on metal or resin minis, though you can pin plastic as well. I selected a Daemon Hunter model that has a decent arm join but has a tendency to be knocked off if his due to it sticking out.


2. I get my tool and prepare them. I use brass rods available from train, craft, or hobby stores. I get mine from Hobby Lobby. 5 x 12 inch (or longer) brass rods for 3.50 dollar. I also use a dremo micro drill bit set, 5 very small bits for 7.00 dollars.

For this job I selected a 1/8inch brass rod.

3. Drill a hole in the large piece, as close to the middle of the joint.

4. Test fit the rod (optional).

5. Cut a piece of rod that is shorter then what you plan on using. A bit longer then flush. Put a drop of paint on the end of the rod.

6. Put the small piece to the rod.

It will leave a small drop of paint where you need to drill.

7. Drill into the smaller piece.

8. Cut a section of rod and place it into the peice and test fit it. If you find the rod too long, you can either trim the end off, or drill the hole a bit deeper.

9. Glue the tip of the rod (insert joke here) the join and the other tip of the rod and insert into the model, hold until dry.

Djinn24 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome